Connecting The Unit To A Home Theatre System - Emerson Dora the Explorer DTE351 Owner's Manual

CONNECTING THE UNIT TO A HOME THEATRE SYSTEM

1. Front Left Speaker
2. Television
3. Center Speaker–can be located on top or below the
television.
4. Sub-woofer–can be located anywhere in the room.
5. Front Right Speaker
NOTES:
• You must change your external TV' s INPUT selection to VIDEO IN or AUX IN, if using an external TV.
If the TV has a remote control, press the INPUT or AUX button on the remote to change the input
selection.
• When connecting the unit, refer to the owner' s manuals of the external TV and receiver/home
stereo, as well as this manual.
• W hen connecting the unit, make sure the power is off and all units are unplugged before making any
connections.
CONNECTIONS (CONTINUED)
6. Viewing/Listening Position–the best listening position is
obtained by positioning the chair, sofa, etc. in the middle
of all the speakers.
7. Rear Left Speaker
8. Rear Right Speaker
9. AV Amplifier w/Dolby Digital Decoder/DTS Decoder
15
Place the subwoofer, front, rear and center
speakers in locations as shown/described
here. After correctly positioning the speakers,
perform the Tone Test on the AV Amplifier and
adjust the volume controls until the desired
sound is achieved. For best results, sit in the
viewing position and have someone adjust the
volumes for you; this will enable you to set
the optimal levels.
NOTE: To avoid scratching the furniture, place
felt pads to the bottom of each speaker.
NOTE:
• The rear speakers can also be located on
the side wall facing the viewing position and
each other. Make sure the viewing position
is located between the two speakers in this
case. Experiment to find optimal position.