Auto Dry Cycle - Haier LDS7HC User Manual

English

AUTO DRY CYCLE

1. Turn the knob to any program except "OFF" to power on. The control panel
will beep once and the dryer will change from "OFF" to the operating status.
2. Set the cycle select dial to required auto dry cycle. The temperature level is
preprogrammed. To change this setting:
• Press the "Temp" button to set a suitable drying temperature.
•
After powering on and selecting the cycle, the dryer selects the pre
programmed temperature. If a different drying temperature is required,
press the "Temp" button to select. There are three available drying
temperatures: High, medium, Low.
•
"Temp" in the "Heavy Duty" cycle is "High". This can not be change.
"Temp" in the "Delicate" cycle is "Low". This can not change;
"Temp" in the "Normal" cycle can be choosen from "High, Medium, Low".
• Press Start/Pause button.
• When starting the machine, close the door first, then press this button.
• If a pause is needed during drying, press this button. Pressing again will
resume operation.
• Regardless of the dryer status (drying, pause or cool down), by turning the
dial to "OFF" position, the off indicator light will flash for 5 seconds and
then go into stand by mode. When machine running, by turning the dial in
any direction, the cycle will automatically turn "OFF".
• After press "Start/Pause" button when machine running, you can choose any
cycle as you like.
Note: To change the cycle press pause, turn dial to new selection and press
"Start/Pause" again.
18