Figure 37 Bandwidth Management Wizard: Configuration; Table 19 Bandwidth Management Wizard: Configuration - ZyXEL Communications P-660HW-DX User Manual

Chapter 4 Bandwidth Management Wizard
Table 18 Bandwidth Management Wizard: General Information
LABEL
Next
Exit
4 Use the second wizard screen to select the services that you want to apply bandwidth
management and select the priorities that you want to apply to the services listed.

Figure 37 Bandwidth Management Wizard: Configuration

The following table describes the labels in this screen.

Table 19 Bandwidth Management Wizard: Configuration

LABEL
Active
Service
Priority
Back
70
DESCRIPTION
Click Next to proceed to the next screen.
Click Exit to close the wizard screen without saving.
DESCRIPTION
Select an entry's Active check box to turn on bandwidth management for the service/
application.
These fields display the services names.
Select High, Mid or Low priority for each service to have your ZyXEL Device use a
priority for traffic that matches that service.
A service with High priority is given as much bandwidth as it needs.
If you select services as having the same priority, then bandwidth is divided equally
amongst those services.
Services not specified in bandwidth management are allocated bandwidth after all
specified services receive their bandwidth requirements.
If the rules set up in this wizard are changed in Advanced > Bandwidth MGMT >
Rule Setup, then the service priority radio button will be set to User Configured.
The Advanced > Bandwidth MGMT > Rule Setup screen allows you to edit these
rule configurations.
Click Back to go back to the previous wizard screen.
P-660HW-Dx User's Guide