Table 99 Icmp Logs; Table 100 Cdr Logs; Table 101 Ppp Logs - ZyXEL Communications P-660HW-DX User Manual

Chapter 18 Logs

Table 99 ICMP Logs

LOG MESSAGE
Firewall default policy: ICMP
<Packet Direction>, <type:%d>,
<code:%d>
Firewall rule [NOT] match: ICMP
<Packet Direction>, <rule:%d>,
<type:%d>, <code:%d>
Triangle route packet forwarded:
ICMP
Packet without a NAT table entry
blocked: ICMP
Unsupported/out-of-order ICMP:
ICMP
Router reply ICMP packet: ICMP

Table 100 CDR Logs

LOG MESSAGE
board%d line%d channel%d,
call%d,%s C01 Outgoing Call
dev=%x ch=%x%s
board%d line%d channel%d,
call%d,%s C02 OutCall
Connected%d%s
board%d line%d channel%d,
call%d,%s C02 Call
Terminated

Table 101 PPP Logs

LOG MESSAGE
ppp:LCP Starting
ppp:LCP Opening
ppp:CHAP Opening
ppp:IPCP
Starting
ppp:IPCP Opening
ppp:LCP Closing
ppp:IPCP Closing
240
DESCRIPTION
ICMP access matched the default policy and was
blocked or forwarded according to the user's setting. For
type and code details, see
ICMP access matched (or didn't match) a firewall rule
(denoted by its number) and was blocked or forwarded
according to the rule. For type and code details, see
Table 110 on page
The firewall allowed a triangle route session to pass
through.
The router blocked a packet that didn't have a
corresponding NAT table entry.
The firewall does not support this kind of ICMP packets
or the ICMP packets are out of order.
The router sent an ICMP reply packet to the sender.
DESCRIPTION
The router received the setup requirements for a call. "call" is
the reference (count) number of the call. "dev" is the device
type (3 is for dial-up, 6 is for PPPoE, 10 is for PPTP).
"channel" or "ch" is the call channel ID.For example,"board 0
line 0 channel 0, call 3, C01 Outgoing Call dev=6 ch=0
"Means the router has dialed to the PPPoE server 3 times.
The PPPoE, PPTP or dial-up call is connected.
The PPPoE, PPTP or dial-up call was disconnected.
DESCRIPTION
The PPP connection's Link Control Protocol stage has started.
The PPP connection's Link Control Protocol stage is opening.
The PPP connection's Challenge Handshake Authentication Protocol stage is
opening.
The PPP connection's Internet Protocol Control Protocol stage is starting.
The PPP connection's Internet Protocol Control Protocol stage is opening.
The PPP connection's Link Control Protocol stage is closing.
The PPP connection's Internet Protocol Control Protocol stage is closing.
Table 110 on page 248.
248.
P-660HW-Dx User's Guide