Figure 150 Wall-Mounting Example - ZyXEL Communications P-660HW-DX User Manual

Wall-mounting Instructions
Complete the following steps to hang your ZyXEL Device on a wall.
See the Hardware Specifications table for the size of screws to use and how far
apart to place them.
1 Select a high position on a sturdy wall that is free of obstructions.
2 Drill two holes for the screws.
3 Be careful to avoid damaging pipes or cables located inside the wall when drilling holes
for the screws.
4 Do not insert the screws all the way into the wall. Leave a small gap of about 0.5 cm
between the heads of the screws and the wall.
5 Make sure the screws are snugly fastened to the wall. They need to hold the weight of
the ZyXEL Device with the connection cables.
6 Align the holes on the back of the ZyXEL Device with the screws on the wall. Hang the
ZyXEL Device on the screws.

Figure 150 Wall-mounting Example

The following are dimensions of an M4 tap screw and masonry plug used for wall mounting.
All measurements are in millimeters (mm).
P-660HW-Dx User's Guide
Appendix A Product Specifications and Wall Mounting
269