Specifications; Heating Specifications; Electrical Specifications; Epa Compliance - Dansons Group GLOW BOY FGB Owner's Manual

HEATING SPECIFICATIONS

Approx. Heating capacity (sq. feet) *
Approx. Fuel burn rate per hour **
Hopper Capacity - Freestanding Step Top
Hopper Capacity— Classic Insert / Built-in
Hopper Capacity - Bay View Freestanding
Hopper Capacity – Bay View Insert / Built-in
¹ Heating capacity will vary depending on floor plan layout of your home, degree of insulation, and
the outside temperature. Fuel size, quality, density and moisture level will also have an effect.
¹¹ Pellet size may affect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as
much as 20%. Use PFI listed fuel for best results, pelletheat.org for further information.
DIMENSIONS
Product subject to
Change without notice.

ELECTRICAL SPECIFICATIONS

Electrical Rating
Watts (operational)
Watts (optional igniter)
A voltage surge protector or ground fault outlet is required for this unit. The warranty on the circuit
board will be voided if surge protection is not installed before operating this unit.
If power outages or disturbances are a concern, you may wish to purchase a gas powered generator,
solar or battery back-up system. Ensure that it is a "Positive" sign wave and a minimum 1000 watts
continual.

EPA COMPLIANCE

This heater is exempt from EPA Phase II requirements, but has been tested for emissions using EPA test
methods by Warnock Hersey , US. Pellet appliances that are designed with the combustion air supply
exceeding 35:1 (by ratio) are exempt from EPA regulations.
Glow Boy Pellet & Biomass
S
S
PECIFICATIONS
PECIFICATIONS
800 – 2,000
1.5 – 5 lbs
90 lbs
40 lbs.
60 lbs
40—60 lbs.
26"
24"
25"
30"
Air Inlet Air Inlet
Bay View Freestanding
24 3/4" 24 3/4"
24"
24" 24"
32 ½"
+ +
Air Inlet Air Inlet
Step Top Freestanding
= 115 Volts 60 HZ 2.0 Amps
= 175 (approximately)
= 475 (approximately)
Approx. Burn time at lowest setting
Approx. Burn time at lowest setting
Approx. Burn time at lowest setting
Approx. Burn time at lowest setting
Shroud 1"
12 1/4" 10 3/4"
7"
Adjustable
Exhaust Exhaust
Hopper
+ +
+
17"
8 1/4"
12 3/4"
24"
Bay View Insert / Built-In
Shroud 1"
12 1/4"
6 1/2" 6 1/2"
Exhaust Exhaust
+ +
17 1/4"
8 1/4" 8 1/4"
12 3/4" 12 3/4"
24"
Classic Insert / Built-In
www.glowboystoves.com
65 hrs
27 hrs
48 hrs
27-48
26"
24"
19"
-
23"
+
+
3 ½"
+
8 1/4"
Air Inlet
24 3/4"
10 3/4"
24"
18 3/4"
+
3 ½" +
8 1/4"
Air Inlet
6 ½"
Exhaust Exhaust
7 3/4"
6 1/2"
Exhaust
7 3/4"
8
8