Dansons Group GLOW BOY FGB Owner's Manual page 22

CAUTION:
DO NOT BLOCK ANY VENT OPENINGS
PELLET VENT MUST MAINTAIN A MINIMUM 3" CLEARANCE TO ANY COMBUSTIBLE.
(INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER).
DO NOT CONNECT THE PELLET VENT TO A VENT SERVING ANY OTHER APPLIANCE OR
STOVE.
DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT.
THE APPLIANCE MUST BY PLACED ON A NON-COMBUSTIBLE SURFACE,
BOTH ON THE HEARTH AND WITHIN THE FRAMED AREA.
(REFER TO FLOOR PROTECTION REQUIREMENTS IN THIS MANUAL.)
The Glow Boy Series Inserts may be framed directly into a wall as either a horizontal or vertical vent
installation. (see figure 27, 28).
The exhaust installation requirements are the same as for a freestanding stove. Refer to
"Installing Freestanding Stove" for information concerning installation and proper hook-up of the exhaust.
NOTE:
Built-in Installations require: Enclosure Spacer Kit — #ACI-3HZ Horizontal Kit or ACI-3VL Vertical Kit
Shroud 1"
12 1/4" 10 3/4"
18 3/4"
24"
Classic Step Top Insert / Built-In
Glow Boy Pellet & Biomass
B - I I
B - I I
UILT N
UILT N
24 3/4"
24"
6 1/2"
Exhaust
+
3 ½"
+ 7 3/4"
8 1/4"
Air Inlet
NSTALLATION
NSTALLATION
Shroud 1"
12 1/4" 10 3/4"
Adjustable
Hopper
24"
Bay View Insert / Built-In
www.glowboystoves.com
26"
24"
19" 6 ½"
-
Exhaust Exhaust
23"
+
+
3 ½"
+
8 1/4"
Air Inlet
7 3/4"
22
22