Dansons Group GLOW BOY FGB Owner's Manual page 38

PROBLEM
Fire burns with a yellow
flame. Fuel builds up in
the burn grate. Window
gets real dirty quickly.
Smoke or smoke smell
spillage.
The stove keeps going
out.
The stove will not shut
off.
Glow Boy Pellet & Biomass
T S
T S
ROUBLE
ROUBLE
CAUSE
1. Insufficient combustion air. *Adjust the air inlet damper.
2. Fuel
3. Air Leaks
4. Combustion Fan
5. Exhaust System
1. Exhaust System
2. Over Feeding. Fuel over-
filling burn grate
1.Fresh unburned fuel or
powder like ash build up in
the grate.
2.No fuel or ashes found in
The burn grate
1.Control
2.Wall Thermostat
HOOTING
HOOTING
SOLUTION
*Check for blockage of air intake both inside as
well as outside.
*Confirm proper placement of burn grate.
*Inspect and clean burn grate.
*Inspect fuel for amounts of fines and debris.
*Change to dry clean fuel.
*Use high quality premium grade fuel.
*Adjust or fine tune feed rates.
*Ensure glass and gasket seated properly
*Ensure door is close and latched securely
*Check ash pan and gasket, secure and tight.
*Check and clean ash build up on fan propellers
and exhaust intakes and venting.
*Check for blockages.
*Check for proper voltage to the stove
*Replace defective part and gasket.
*Check for blockage, ash build.
*Inspect vent cap and clean out tee.
*Too many elbows, to long of run, or change size
*Protect venting from extreme weather elements.
*Hi-Heat RTV silicone all joints even
manufactured. Ensure venting is gas tight.
*Inspect exhaust fan and gasket area, ensure a
tight fit
*Proper maintenance and cleaning.
*Check air inlet damper for proper setting.
*Adjust feed rate to lower level
*Check air inlet damper, may need more air.
*Fine tune feed rate, to lower amount of fuel
*Ensure good quality day fuel supply.
*Proper maintenance and cleaning.
*Adjust air inlet damper to reduce amount of air
to burn grate. Exhaust temperature to low and
temperature disk is turning off stove.
*Adjust control to increase fuel feed rate.
*Press OFF touch pad, the stove will continue to
run for 30 minutes after the exhaust has cooled
properly
*Confirm mode of operation
*Ensure wall thermostat is turn down below the
room temperature.(Thermostat On/Off Mode)
*Unit will not shut off in the (Thermostat Low/
High mode). You must press the OFF touch pad.
www.glowboystoves.com 38
38