Projector Programming Commands; Projector Power State Controls; Command Inventory - Smart Technologies SMART Board 800i5-SMP Configuration And User's Manual

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
3. Configure your serial interface settings using the values from the table in the previous section,
and then press ENTER.
An "invalid cmd= ? for help" message appears, and the > character appears as a command
prompt on the following line.
N
N O T E
If no message or an error message appears, your serial interface configuration isn't correct.
Repeat step 3.
4. Type commands to configure your settings.
N
N O T E S
To see a list of commands available in the current operating mode, type ? and then
o
press ENTER.
If you're using a terminal emulation program, turn on your program's local echo setting
o
to see characters as you type them.

Projector programming commands

This section documents the projector programming commands.

Projector power state controls

Your projector responds to commands only at certain power states and times.
There are five projector power states:
Powering (startup)
l
On (operating)
l
Cooling
l
Confirm off
l
Idle (Standby mode)
l

Command inventory

Your projector responds to the commands in the tables on the following pages. To see a list of valid
commands in the projector's current power state, type ? and press ENTER.
73