Smart Technologies SMART Board 800i5-SMP Configuration And User's Manual page 37

C H A P T E R 3
Using your interactive whiteboard system
N
N O T E
Low Power mode reduces your interactive whiteboard system's power consumption when it is in
Standby mode.
To set the projector system to enter Low Power mode automatically whenever it enters Standby
mode, hold down the Power
seconds, the Power
enabled.
The following diagram and table describe the components of the ECP.
Number Function
Left side
1 USB A receptacle (for USB drives)
N
N O T E
USB drives that you connect to this receptacle are only accessible to the room
computer (the computer connected to the USB 1 receptacle).
Front
2
Power
3 Volume control
4 Input selection
Back
5 Two mini USB B receptacles (connect to room computer and laptop)
6 11-pin connector (connects to ECP cable harness)
7 4-pin connector (for room control)
25
and Input buttons at the same time for five seconds. After five
button blinks amber for two seconds to indicate that Low Power mode is
button and status indicator light