Pneumatic Tires; Tire Chains; Clutch And Brake - Cub Cadet 71 Operator's Manual

PNEUMA TIC TIRES
OPERATING PRESSURE FOR TIRES
REAR WHEEL WEIGHTS
Inflate the front and rear tires for normal
or heavy load operations as shown in the fol-
lowing table.
Rear wheel weights increase traction and
reduce wheel slippage. The weights weigh
approximately 26 pounds each. They are
attached to each rear wheel with two bolts,
lock washers, and hex. nuts.
If additional weight is desired. a second set
of weights can be attached to each first weight
by using two longer bolts.
MOUNTING TIRES ON THE RIM
TIRE CHAINS
After mounting a new or old tire on the
rim, inflate it to 20 pounds pressure to seat
the tire bead on the rim flange and to prevent
the tire from creeping and shearing off thevalve.
Then deflate the tire to the correct
operating pressure.
Tire chains will provide additional traction
for wet ground conditions, when plowing snow,
or pulling heavy loads. Rear wheel weights
are recommended when using chains.
CLUTCH AND BRAKE
(International Cub Cadet 71, 102 and 122 Tractors)
Clutch disengaged:
tractor must be
free to coast.
Clutch engaged clutching zone "
Top surface of
pedal foot pad
Neutral zone:
Both brake and clutch
are disengaged when.
pedal is in this zone.
/)
(/
Peda.! return stop
Free movement
(3/16-inch)
7~.
Braking zone:
Brake must be engaged '"
when pedal is in this zone.
"/
f";;"~ "
---~J ' "
"~~ " I
-~ 7 " "'-..
-"- "'-
-.;::".. "'-.. "
~~===~:::::
3/4 -inch minimum / --
Foot support
(Models 102 and 122)
\1'""') nIl
1-5/16-inch maximum
Brake must be fully engaged when/
pedal arm reaches this position.
t ~.:==~ ]
!
Pedal stop
Foot support
(Model 71)
A-84133
Illust. 21
Clutch and brake adjustments.
21