Setting The Clock - Hitachi AX-67 Operating Instructions Manual

Setting the clock

Setting the clock
• Press the POWER/STANDBY
button to put the unit into
standby mode.
• Press and hold down the
MEMO/C.ADJ button on the unit
until 24H flashes in the display.
• Press the SKIP/TUN buttons to
change between 12 and 24
hour clock format.
• Press the MEMO/C.ADJ button
to confirm your choice.
• Press the SKIP/TUN buttons to
change the hours.
• Press the MEMO/C.ADJ button
to confirm your choice.
• Press the SKIP/TUN buttons to
change the minutes.
• Press the MEMO/C.ADJ button
to confirm your choice and start
the clock.
The clock operates in a 12 or 24 hour format.
Setting the daily timer
Use the daily timer to turn the
system on at a set time.
• Press the MODE/REMAIN
button twice.
• Press and hold the MEMO/
C.ADJ button until the timer
flashes in the display.
• Press the SKIP/TUN buttons to
set the hour to turn on.
• Press the MEMO/C.ADJ button
to confirm your choice.
• Press the SKIP/TUN buttons to
set the minutes.
• Press the MEMO/C.ADJ button
to confirm your choice.
• Press the POWER/STANDBY
button to put your unit into
standby mode.
*To turn on the timer, press and
hold the TIMER/SLEEP button
until TIMER appears in the
display.
*To turn off the timer, press and
hold the TIMER/SLEEP button
until TIMER disappears from the
display.
Setting the sleep timer
Use the sleep timer to turn your
system off after a set amount of
minutes.
Play a CD or set a radio station.
Press the SLEEP button
continuously to choose between
10 and 90 minutes (in ten
minute intervals). If you set sleep
for 50 minutes, your system will
turn itself off after 50 minutes.
Setting the snooze feature
Use the snooze feature to turn
off the unit in daily timer mode.
When your unit turns on in daily
timer mode, press the SNOOZE
button. The unit will
automatically go back into
standby mode and then turn
itself on again 5 minutes later.
The system will switch off
automatically 1 hour later.
i
Information
You will only have 3
seconds to perform
each stage of the
instructions on this
page. If you take any
longer the display will
go back to the
previously set time
display.