Using The Tuner - Hitachi AX-67 Operating Instructions Manual

Using the Tuner

Using the Tuner
Press the FUNCTION button on
the remote control until TUNER
appears in the display. Press the
STOP/BAND button to change
between FM and MW
wavebands. Press the SKIP/
SEARCH/TUNING buttons to
change the frequency. Press and
hold down the SKIP/SEARCH/
TUNING buttons to search
quickly for the nearest strong
signal.
Changing FM reception
When you are listening to an
FM stereo broadcast, 'STEREO'
will show in the display. If the
broadcast is not very good,
press the FM ST/MONO. button
on the unit to change between
stereo and mono. The reception
should improve in mono mode
but you will lose any stereo
effect.
Presetting radio stations
Find the radio station that you
want to make a preset station.
• Press the MEMO/C.ADJ button
on the unit.
• Press the REPEAT/M-UP button
on the remote control continually
to select which preset number
the station will be set to.
• Press the MEMO/C.ADJ button
to confirm your choice.
• Repeat the process presetting
other stations. You can preset 10
stations on FM and 10 stations
on MW wavebands.
• To listen to your preset station,
press the STOP/BAND button to
select the waveband and then
the REPEAT/M-UP button until
you reach the correct preset
number.
i
Information
Make sure that you
have extended the FM
aerial before using the
tuner function.
If you disconnect the
mains power to your
unit, you will lose all of
your previously stored
stations unless you
have fitted back up
batteries.