Epson WorkForce AL-M400DN User Manual page 78

Item Settings (default in bold)
Form 5 ... 64 ... 128Lines
CR Function CR, CR+LF
LF Function LF, CR+LF
Tray Assign 4K, 5S, 4
*1
Available only when downloaded fonts are available.
*2
Depending on the font that has been selected.
FontSource
Sets the default font source.
Font Number
Sets the default font number for the default font source. The available number depends on the settings
you made.
Pitch
Specifies the default font pitch if the font is scalable and of fixed-pitch. You can select from 0.44 to
99.99 cpi (characters per inch), in 0.01-cpi increments. This item may not appear depending on the
FontSource or Font Number settings.
Height
Specifies the default font height if the font is scalable and proportional. You can select from 4.00 to
999.75 points, in 0.25-point increments. This item may not appear depending on the FontSource or
Font Number settings.
SymSet
Selects the default symbol set. If the font you selected in FontSource and Font Number is not available
in the new SymSet setting, the FontSource and the Font Number settings are automatically replaced
with the default value, IBM-US.
Form
Selects the number of lines for the selected paper size and orientation. This also causes a line spacing
(VMI) change, and the new VMI value is stored in the printer. This means that later changes in the
Page Size or Orientation settings cause changes in the Form value, based on the stored VMI.
AL-M300/AL-M400 Series
Using the Control Panel
User's Guide
78