Nap Timer (Buzzer Alarm Only); Dimmer Control - Emerson Research iC200 Owner's Manual

Nap Timer (Buzzer Alarm Only)

The Nap timer function will wake you to the buzzer alarm after a nap of up to 99
minutes without the need to change your regular Alarm 1 or Alarm 2 settings.
1.) If the system is playing, shut the power ' Off' .
2.) Press the Nap button on the top panel.
The display will briefly show "n:30"
and the NAP indicator appears.
After 30 minutes the buzzer alarm
will turn on to wake you up.
3.) To change the amount of nap time depress and hold the Nap button and press
the Tuning/Skip
the remote control to decrease or increase the amount of naptime from 2
minutes to 99 minutes.
NOTE: When you change the Nap timer from the original 30-minute default
setting your new setting becomes the new default setting.
For example if you change the Nap timer setting from 30 minutes to 45
minutes, 45 minutes becomes the new default Nap timer setting until you
change it again.
To cancel Nap Timer, press the SNOOZE button.

Dimmer Control

The display dimmer control was set to the High position at our factory.
If you find the display to be too bright for sleeping, slide the Dimmer switch to the
Low position.
iC200_NCab050307.p65
or buttons on the top panel or the
38
38
/ buttons on
3/5/2007, 11:29