Emerson Research iC200 Owner's Manual page 28

2.) Select the correct adapter for your particular iPod
model from among the 5 different adapters included.
Each adapter is engraved with the name and/or size
®
of an iPod model. Place the selected adapter in the
docking area so that the iPod
passes through the opening in the adapter.
Gently press downward on the adapter until it "clicks"
and locks in place.
®
3.) Mount the iPod
This bracket provides support and prevents your iPod
backward when you operate the iPod
CAUTION: You must use this support bracket with all iPod
prevent possible damage to the iPod
NOTE: If you are using either the 30GB or 60GB fifth generation iPod
models with video capability or the 2G (Second Generation) iPod
use the adapters that were supplied with the iPod
They will fit correctly in the docking cradle of this system.
IMPORTANT
• If you are using a "1G (First Generation) iPod
you will notice that the iPod
this unit is not properly aligned with the opening in
the iPod ® nano adapter.
• Before inserting the iPod
docking area you must slide the iPod
connector to the left position, and then place the
nano adapter into the docking area.
iC200_NCab050307.p65
® 30-pin connector
Support Bracket on the docking station as shown.
®
® 30-pin connector on
®
nano adapter into the
27
27
®
® from moving too far
controls.
®
connector.
®
at time of purchase.
®
nano"
® 30-pin
3/5/2007, 11:29
®
models to
®
®
nano,