Operating Instructions; Setting The Time, The First Time - Emerson Research iC200 Owner's Manual

O P E R AT I N G I N S T R U C T I O N S
• Make sure that you have extended the AC power cord to its full length.
The FM antenna is built into the power cord.
• Make sure that you have installed two fresh "AAA" alkaline batteries in
the remote control handset.

Setting The Time, The First Time

IMPORTANT: The first time you connect your new SmartSet
the AC outlet the internal computer will automatically set the time correctly for
the Eastern Time Zone, which is the initial default setting. The display will
scan for a few seconds and then show the correct Day and Time in the Eastern
zone. If you live in the Eastern Time zone, there' s nothing else to do. Your
clock is set correctly and running.
If you do not live in the Eastern Time zone you must change the default zone
display to your own zone. You only do this one time and the SmartSet
the new default zone setting and will always return to that setting after a power
interruption.
There are 7 time zones programmed into your SmartSet
To change the default time zone display, depress the Time Zone button.
The number "02" will appear on the display
indicating that the default zone is ZONE 2,
Eastern Time.
iC200_NCab050307.p65
ZONE 1 — Atlantic Time
ZONE 2 — Eastern Time (Default Setting)
ZONE 3 — Central Time
ZONE 4 — Mountain Time
ZONE 5 — Pacific Time
ZONE 6 — Yukon Time
ZONE 7 — Hawaiian Time
13
13
® clock radio to
®
will remember
® clock radio as follows:
3/5/2007, 11:29