Table of Contents
Advertisement
B
Lowering the Flash
Push the flash down gently to lower the flash until it clicks into place when not in use (A 5).
C
The Flash Lamp
The flash lamp indicates the status of the flash when you press the
shutter-release button halfway.
• On: The flash fires when a picture is taken.
• Flashing: The flash is charging. The camera cannot take pictures.
• Off: The flash does not fire when a picture is taken.
If the battery level is low, the monitor turns off while the flash is charging.
C
The Flash Mode Setting
• The setting varies with the shooting mode.
➝ "Available Features" (A 52)
➝ "Default Settings" (A 61)
• Some settings cannot be used with other functions (A 65).
• The flash mode setting applied in A (auto) mode is saved in the camera's memory even after the
camera is turned off.
C
Effective Range of the Flash
When ISO sensitivity is set to Auto, the flash has a range of approx. 0.5 to 6.0 m (1 ft 8 in. to 19 ft) at
the maximum wide-angle zoom position and a range of approx. 1.5 to 3.2 m (5 ft to 10 ft) at the
maximum telephoto zoom position.
C
Red-eye Reduction
This camera uses "Advanced Red-Eye Reduction (In-Camera Red-Eye Fix)."
If the camera detects red eye while saving an image, the affected area is processed to reduce red-
eye before the image is saved.
Note the following when shooting:
• More time than usual is required to save images.
• Red-eye reduction may not produce the desired results in all situations.
• In rare cases, areas of the image that are not affected by red-eye may be processed by red-eye
reduction. In these cases, select another flash mode and take the picture again.
55
Advertisement
Table of Contents
