READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTIONS FOR ATTACHING LYTESPOT
INSTRUCTIONS FOR ATTACHING LYTESPOT
SINGLE CIRCUIT TRACK SYSTEMS
1. Insert into LYTESPAN TRACK. (Fig. 1) LOCKING LEVER
must be on the same side of track as BEAD.
2. Rotate FITTING clockwise until LOCKING LEVER snaps
and locks in place. (Fig. 2 & 3)
3. To remove: depress LOCKING LEVER, then rotate FITTING
90° counterclockwise.
BEAD
LOCKING
LEVER
Fig. 1
INSTRUCTIONS FOR CONVERTING LYTESPOT
ATTACHMENT FITTINGS TO OPERATE ON 2
CIRCUIT TRACK
See Fig. 4. BRASS CONTACT can be raised or lowered.
Broken line indicates position for 1 circuit or lower circuit
of 2 circuit track system.
To convert attachment FITTING for upper circuit of 2 circuit
track, raise BRASS CONTACT to high position by lifting
CONTACT as high as stop permits and CONTACT clicks
into place.
For use with Lytespan
®
TO
LYTESPAN TRACK
FITTING
®
TO LYTESPAN
®
®
Track Systems Only
Fig. 2
BRASS CONTACT
Fig. 4
LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA 02720
INSTRUCTION SHEET NO.
I S : 6 4 2 2 M C
0498
Page 1 of 2
TRACK
®
Fig. 3
LOCKING
LEVER