Using The Autominblock Command To Enable The Minimum Mode - Cisco Catalyst 8540 MSR Configuration Manual

Input Translation Table Management
Command
Step 3 Switch(config-if)# atm input-xlate-table
minblock vpi vpi-value block-size force
Step 4 Switch(config-if)# exit
The CLI-specified non-force minblock interface configuration command is overridden when one or
more of the following four conditions are present:
•
•
•
•

Using the Autominblock Command to Enable the Minimum Mode

Use the autominblock command to enable the automatic analysis of minimum ITT needs of each
interface/VPI in the system. The system uses this information for a subsequent ITT request, and specifies
minimum block sizes in startup configuration generation via the insertion of minblock commands. This
is a global configuration mode command.
Command
Switch(config)# atm input-xlate-table autominblock Specifies autominblock mode.
ATM Switch Router Software Configuration Guide
7-98
When the minblock command is processed and the existing PVCs on the interface are sufficient to
require, at a minimum, the block size specified in the CLI command. (Under these circumstance, the
block size is subsequently determined by analysis, rather than the CLI value.)
When a VC is added to the interface/VPI referred to by the CLI command, and requires, at a
minimum, the block size specified in the CLI command. (Under these circumstances, the block size
is subsequently determined by analysis).
When a VC is deleted from the interface/VPI referred to by the CLI command. (Under these
circumstances, the block size is subsequently determined by analysis.
When a nonvolatile-generation operation is performed (e.g. initiated by entering the write terminal
command).
Chapter 7 Configuring Virtual Connections
Purpose
Repeats this command for as many VPIs are
required.
Returns to global configuration mode.
Purpose
OL-7396-01