Cisco Catalyst 8540 MSR Configuration Manual page 169

Chapter 7 Configuring Virtual Connections
Command
Step 3 Switch(config)# interface atm
card/subcard/port[.vpt#]
Switch(config-if)#
Step 4 Switch(config-if)# atm soft-vc source-vpi
source-vci dest-address atm-address dest-vpi
dest-vci [enable | disable] [upc upc] [pd pd]
[rx-cttr index] [tx-cttr index]
[retry-interval [first interval]
[maximum interval]] [redo-explicit
[explicit-path precedence {name path-name |
identifier path-id} [upto partial-entry-index]]
[only-explicit]] [hold-priority priority]
[timer-group name]
The row index for rx-cttr and tx-cttr must be configured before using this optional parameter. See
Note
Chapter 9, "Configuring Resource Management."
Examples
The following example shows the destination ATM address of the interface connected to User D:
Switch-C# show atm addresses
Switch Address(es):
47.00918100000000400B0A2A81.00400B0A2A81.00 active
47.00918100000000E04FACB401.00E04FACB401.00
Soft VC Address(es):
<Information deleted>
47.0091.8100.0000.00e0.4fac.b401.4000.0c80.9000.00 ATM1/1/0
47.0091.8100.0000.00e0.4fac.b401.4000.0c80.9010.00 ATM1/1/1
47.0091.8100.0000.00e0.4fac.b401.4000.0c80.9020.00 ATM1/1/2
<Information deleted>
The following example shows how to configure a soft PVC on Switch B between interface ATM 0/0/2,
source VPI = 0, VCI = 1000; and Switch C, destination VPI = 0, VCI = 1000 with a specified
ATM address (see
Switch-B(config)# interface atm 0/0/2
Switch-B(config-if)# atm soft-vc 0 1000 dest-address
47.0091.8100.0000.00e0.4fac.b401.4000.0c80.9010.00 0 1000
OL-7396-01
Figure 7-6):
Configuring Soft PVC Connections
Purpose
Selects the interface to be configured.
Configures the soft PVC connection.
ATM Switch Router Software Configuration Guide
7-21