Initiate Wi-Fi Protection Setup - Cisco TES301 User Manual

Ip managed services home gateway

Hide thumbs Also See for TES301:

Table of Contents

Chapter 5 Using the LCD

Tap the right arrow. A confirmation request appears.

Tap the right arrow again to accept the change or tap the left arrow to cancel the

request.

Tap the left arrow to exit the SSID details page.

Initiate Wi-Fi Protection Setup

Complete the following steps to initiate Wi-Fi Protection Setup.

Before you proceed:

At least one SSID must already be set up. Go to the Wi-Fi (on page 40) section to



setup an SSID.

Wi-Fi must be turned on for the SSID you are managing. Go to Turn Wi-Fi Off or



On (on page 60) if Wi-Fi is not already turned on.

From the Wi-Fi Network Status page, tap the down or up arrow keys to highlight

the SSID you wish to manage.

4038767 Rev A

Table of Contents