Symantec 10551441 - AntiVirus Corporate Edition Installation Manual page 124

124 Installing Symantec AntiVirus servers
Deploying the server installation across a network connection
Install Symantec AntiVirus with NetWare Secure Console enabled
After installation, you must copy Vpstart.nlm from the installation directory to
the Sys:\System directory and then use the /Install switch to load Vpstart.nlm
for the first time. If you selected automatic startup during installation, the
NLMs will load automatically the next time that the server restarts. If you
selected manual startup, you must manually load Vpstart.nlm every time that
you restart the server.
Note: At the NetWare console, do not add the path to the commands specified.
Type each command exactly as it appears. These NetWare commands are case-
sensitive.
To manually load the Symantec AntiVirus NLMs for the first time while
running NetWare Secure Console
1 From the Sys:\Sav default installation directory (or the directory that was
specified during installation), copy Vpstart.nlm to the Sys:\System
directory.
2 At the server console, type the following:
Vpstart /install /SECURE_CONSOLE SYS:\SAV\VPSTART.NLM
Warning: You only need to perform this procedure one time after software
installation. If you use the /Install switch again, you will overwrite any
current configuration settings.
To manually load the Symantec AntiVirus NLMs after NLM installation while
running NetWare Secure Console
At the server console, type the following:
◆
Vpstart.nlm