Pioneer Super Tuner IIID DEH-P4100 Operation Manual page 62

)
( Connecting the units
(
English)
aNote
• When this unit is installed in a vehicle without
ACC (accessory) position on the ignition switch.
t'ed cable must be wired to the terminal that
can detect the operation of the ignition key.
Other·wise. battery drain may result.
• Use this unit
In
other than the following
conditions could result in fire or malfunction,
- Vehicles with a 12·volt battery and negative
grounding,
-Speakers with 50 W (output value) and 4 ohm
to 8 ohm (Impedance value).
• To prevent shod·circult. overheating or
malfunction. be sure to follow the directions
below.
- Disconnect the negative terminal of the
battery before installation,
-Secure the wiring with cable clamps or
adheSive tape. To protect the wiring. wrap
adheSive tape around them where they lie
against metal parts,
- Place all cables away from moving parts. such
as gear shift and seat rails.
- Place all cables away from hot places. such
as near the heater outlet.
- Do not pass the yellow cable through a hole
into the engine compartment to connect to a
battery.
-Cover any disconnected cable connectors
With insulating tape.
- Do not shorten any cables.
- Never cut the insulation of the power cable of
this unit in order to share the power to other
eqUipment. Current capacity of the cable is
limited.
- Use a fuse of the rating prescribed.
- Never wire the speaker negative cable directly
to ground,
- Never band together multiple speaker's
negative cables.
• Control signal is output through blue/white cable
when this unit is powered on, Connect it to an
external power amp's system remote control or
the vehicle's auto,antenna relay control ter'minal
(max. 300 mA. 12 V DC). If the vehicle is equipped
with a glass antenna. connect it to the antenna
booster power supply terminal.
• Never connect blue/white cable to external
power amp's power terminal, Also. never connect
It to the power terminal of the auto antenna,
Otherwise. battery drain or malfunction may
resu It.
• Ip·BUS connectors are color·coded. Be sure to
connect connectors of the same color.
• Black cable is ground. This cable and other
product's ground cable (especially. high-current
products such as power amp) must be wired
separately. Otherwise, fire or malfunction may
result if they are accidentally detached,
No ACC position ACC position