Pioneer DEH-P4100UB Installation Manual

CD RECEIVER
AUTORADIO CD
RADIO CD
DEH-P4100UB
Installation Manual
Manuel d'installation
Manual de instalación
Printed in China
Imprimé en Chine
<YRD5262-A/S> UC <KNANX> <08H00000>
Installation English
2. Secure the mounting sleeve by
Note
using a screwdriver to bend the
• Check all connections and systems before final
metal tabs (90°) into place.
installation.
Mounting sleeve
• Do not use unauthorized parts. The use of
Dashboard
unauthorized parts may cause malfunctions.
• Consult with your dealer if installation requires
182
drilling of holes or other modifications of the
vehicle.
53
• Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
• The semiconductor laser will be damaged if it 3. Install the unit.
overheats. Install this unit away from hot places
• Use commercially available parts when
such as near the heater outlet.
installing.
• Optimum performance is obtained when the unit
is installed at an angle of less than 60°. Nut
Filrewall or
60°
metal support
Metal strap
Screw
DIN Front/Rear-mount
This unit can be properly installed either from
Screw (M4 8)
"Front" (conventional DIN Front-mount) or
"Rear" (DIN Rear-mount installation, utilizing
threaded screw holes at the sides of unit
chassis). For details, refer to the following
installation methods.
• Make sure that the unit is installed securely
DIN Front-mount
in place. Unstable installation may cause this
unit to malfunction, such as sound skip.
Installation with metal strap and
Removing the Unit
screws
1. Extend top and bottom of the trim
1. Insert the mounting sleeve into the
ring outwards to remove the trim
dashboard.
ring. When reattaching the trim
• When installing in a shallow space, use a
ring, push the trim ring onto the
supplied mounting sleeve. If there is enough
space behind the unit, use factory supplied unit until it clicks. (If the trim ring
mounting sleeve.
is attached upside down, the trim
ring will not fit properly.)
• It becomes easy to remove the trim ring if the
front panel is released.
Trim ring
Installation English
2. Insert the supplied extraction keys 3. Tighten two screws on each side.
• Use either truss screws (5 mm × 8 mm)
into both sides of the unit until
or flush surface screws (5 mm × 9 mm),
they click into place.
depending on the shape of screw holes in the
bracket.
Screw
Dashboard or Console
Factory radio mounting bracket
3. Pull the unit out of the dashboard.
Fastening the front panel
DIN Rear-mount
If you do not plan to detach the front panel,
the front panel can be fastened with supplied
1. Extend top and bottom of the trim
screw.
ring outwards to remove the trim
ring. When reattaching the trim ring,
push the trim ring onto the unit until
it clicks. (If the trim ring is attached
upside down, the trim ring will not
fit properly.)
Screw
• It becomes easy to remove the trim ring if the
front panel is released.
Trim ring
2. Determine the appropriate position
where the holes on the bracket and
the side of the unit match.