Table of Contents
Advertisement
SpeciFicatiOnS
Electrical Input 120 V~ / 60 Hz / 7.5 A (Rated)
Belt Speed
1,250 FPM (No Load)
Belt Size
3" x 21"
Accessories
Dust Bag / 120 Grit Belt
unpacking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon as
possible.
aSSeMBlY
read the entire iMpOrtant
SaFetY inFOrMatiOn
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
FrOM accidental
OperatiOn:
turn the trigger of the tool off
and unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
reV 04j; 09k
SKU 90045
e194601
tO preVent
SeriOuS injurY
For technical questions, please call 1-800-444-3353.
to remove/install a Sanding Belt:
trigger
(66)
Figure a
FrOnt wheel FraMe (53)
1.
Pull out on the Tension Lever of the Front
Wheel Frame (53), and slide the Sanding
Belt (46) out. (See Figure a.)
2.
Slide a new Sanding Belt (46) on. Then,
push in on the Tension Lever of the Front
Wheel Frame (53). (See Figure a.)
3.
Plug the Power Cord (14) into the
nearest 120 volt, grounded, electrical
outlet.
cautiOn! the machined parts near the
tension adjuster (29) may be sharp.
wear work gloves when adjusting the
tension.
tenSiOn
adjuSter
(29)
Figure B
4.
Grip the Belt Sander firmly with both
hands. Lift the tool and squeeze the
Trigger (66). As the Sanding Belt (46)
turns, observe the Sanding Belt to see
if it is turning on-center and not moving
to the right or left. If the Sanding Belt
moves to the right or left, while wearing
heavy work gloves, turn the Tension
Adjuster (29) right or left until the
Sanding Belt turns on-center. Then, turn
Sanding
Belt (46)
tenSiOn leVer OF
Switch lOck
Page 9
trigger
(66)
leFt
hOuSing
(18)
Hide quick links:
Advertisement
Table of Contents
