Safety Warnings Common For Sanding Operations - Chicago Electric 93431 Set Up And Operating Instructions Manual

the power tool before making any
adjustments, changing accessories,
or storing power tools. Such
preventive safety measures reduce
the risk of starting the power tool
accidentally.
d. Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or
these instructions to operate the
power tool. Power tools are dangerous
in the hands of untrained users.
e. Maintain power tools. check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tool's operation. If damaged, have
the power tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
f. Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g. use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5. Service
have your power tool serviced by a
a.
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
Safety Warnings common for
Sanding Operations
1. This power tool is intended to
function as a sander. Read all safety
warnings, instructions, illustrations
SKU 93431 For technical questions, please call 1-800-444-3353.
and specifications provided with
this power tool. Failure to follow all
instructions listed below may result in
electric shock, fire and/or serious injury.
2. Operations such as grinding, wire
brushing, polishing or cutting-off are
not recommended to be performed
with this power tool. Operations for
which the power tool was not designed
may create a hazard and cause personal
injury.
3. Do not use accessories which
are not specifically designed
and recommended by the tool
manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
The rated speed of the accessory
4.
must be at least equal to the
maximum speed marked on the power
tool. Accessories running faster than
their RATED SPEED can break and fly
apart.
5. The outside diameter and the
thickness of your accessory must
be within the capacity rating of
your power tool. Incorrectly sized
accessories cannot be adequately
guarded or controlled.
6. The arbor size of wheels, flanges,
backing pads or any other accessory
must properly fit the spindle of the
power tool. Accessories with arbor
holes that do not match the mounting
hardware of the power tool will run out
of balance, vibrate excessively and may
cause loss of control.
7. Do not use a damaged accessory.
Before each use inspect the
accessory such as abrasive wheels
for chips and cracks, backing pad
for cracks, tear or excess wear,
Page 4