Meyer Sound MJF-212A Operating Instructions Manual page 2


DEClARATION Of CONfORmITy ACCORDING TO ISO/IEC GUIDE 22 AND EN 45014
manufacturer's Name:
Meyer Sound Laboratories Inc.
manufacturer's Address:
2832 San Pablo Avenue
Berkeley, CA 94702-2204, USA
declares that the product
Product Name: MJF-212A loudspeaker
Product Options: All
conforms to the following Product Specifications
Safety:
EN60065: 2002
IEC60065: 2001
EN55103-1: 1997 emission 1
EmC:
EN55103-2: 1997 immunity 2
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
©2007 Meyer Sound. All rights reserved.
MJF-212A ™ High-Power Stage Monitor Operating Instructions
The contents of this manual are furnished for informational purposes only, are subject to change without notice, and should not be construed as a
commitment by Meyer Sound Laboratories Inc. Meyer Sound assumes no responsibility or liability for any errors or inaccuracies that may appear
in this manual. Except as permitted by applicable copyright law, no part of this publication may be reproduced, stored in a retrieval system, or
transmitted, in any form or by any means, electronic, mechanical, recording or otherwise, without prior written permission from Meyer Sound.
MJF-212A, Galileo, Compass, Intelligent AC, RMS, and all alphanumeric product names are trademarks of Meyer Sound. Meyer Sound, Meyer
Sound MAPP Online, and SIM are registered trademarks of Meyer Sound Laboratories Inc. (Reg. U.S. Pat. & TM. Off.). All third-party trademarks
mentioned herein are the property of their respective trademark holders.
Printed in the U.S.A.
Part Number: 05.157.005.02 A
ii
Supplementary Information
The product herewith complies with the requirements of the Low
Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC.
Office of Quality Manager
Berkeley, California USA
June 1, 2007
European Contact: Your local Meyer Sound dealer or Meyer Sound
Germany, GmbH. Carl Zeiss Strasse 13, 56751 Polch, Germany.
Telephone: 49.2654.9600.58 Fax: 49.2654.9600.59
Environmental specifications for Meyer Sound Electronics products
Operating temperature
Non-operating temperature
Humidity
Operating altitude
Non-operating altitude
Shock
Vibration
Made by Meyer Sound Laboratories
Berkeley, California USA
European Office:
Meyer Sound Lab. GmbH
Carl Zeiss Strasse 13
56751 Polch, Germany
0°C to +45°C
-40°C to +75°C
to 95% at 35°C
to 4600 m (15,000ft)
to 6300 m (25,000ft)
30 g 11 msec half-sine on each of
6 sides
10 Hz to 55 Hz (0.010 peak-to-peak
excursion)
C
US