Initial Settings - Hitachi 42PD8700C Instructions For Use Manual

Table of Contents

Advertisement

Initial Settings

When the TV is turned on for the first time,
IDTV is on first. Because this is the first time
that IDTV has been used, there are no chan-
nels stored in the memory.
When the TV is turned on for the first time,
the menu for the language selection ap-
pears on the screen. The message "Wel-
come please select your language!" is
written in all language options sequentially
in the menu on the screen.
By pressing
or
language you want to set and press "OK"
button. In the menu "Set Language" is writ-
ten next to "OK" item to indicate that "Press
OK button to set the highlighted language
option."
You can get information about the menu us-
age by pressing "
button again to exit the help menu.
After pressing OK, the First time Installation
Menu will appear on screen.Press
buttons, select country item you want to set
and press "OK" button
First time installation
Choose Country
Set country and continue installation
OK
After the First time Installation is set, the fol-
lowing message appears on the screen.
Do you want to start automatic search?
Yes
• To start automatic search, select "Yes", to
cancel select "No".
• To select an option "Yes or No", highlight
the item by using
press "OK" button.
The IDTV will automatically tune to the VHF
and UHF transmission channels looking for
digital terrestrial.
TV broadcasts and displaying the names of
channels found. This process will take
about five minutes. To cancel searching, you
buttons highlight the
" button. And press "
or
GERMANY
No
or
buttons and
can press "
" button at any time during the
process.
Automatic Search
Codec 4:3
Codec 16:9
Searching UHF channels 62. Please wait. This will take a few minutes
Cancel searching
MENU
After Automatic Search process is com-
pleted, the following message asking for
analogue channel search appears on the
screen. TV switches to the analogue TV
mode.
Do you want to search for
analogue channels?
"
Press the "OK" button to search for ana-
logue channels.The following menu ap-
pears on the screen for analogue channel
search.
Language
Country
PLEASE CHECK ANTENNA CABLE
AUTO. PROGRAMMING SYSTEM
In initial aps menu:
Press the BLUE button to cancel APS if you
d o n o t wan t t o d e l e t e yo u r e xi s t i n g
programme list.
To continue APS, first select the language
and country by pressing
then press the RED or "OK" button.
During initial aps the following message ap-
pears on the screen.
- 9 -
Yes
No
AUTO PROGRAM
English
UK
OK
Cancel
/
button and

Advertisement

Table of Contents
loading

Table of Contents