Measurements And Units; Selecting The Units Of Measurement - Suunto Vector User Manual

1.5 MEASUREMENTS AND UNITS

The Wristop Computer supplies two units of measure: metric or imperial.
Metric Unit of Measure
m
m/min
°C
mbar

1.5.1 Selecting the Units of Measurement

To change the unit of measure displayed:
1. Check the mode indicator. If the mode arrow is not on TIME, PRESS the [Mode] button until the arrow is
directly below TIME on the Mode Indicator Bar.
2. PRESS the [Mode] and [Select] buttons simultaneously and hold in for 3 seconds. Field 1 will display "SET"
momentarily and then display "UNI" (Fig. 43).
Note: If the user does not press any button for 1 minute in the setup mode, the display will automatically exit
setup.
WARNING: If the user presses the [Select] button (and does not hold for 2 seconds) while in the "UNI" setting
mode, the user will be in the Pressure Sensor Calibration. Refer to the next section for details.
3. PRESS the [Select] button and hold in for 2 seconds. Located to the right in Field 2, "m" or "ft" will begin to
flash.
4. PRESS the [+] button to toggle between "m" and "ft".
5. At the unit of measure desired, PRESS the [Select] button to move to the next unit. Located below the "m" or
"ft" in Field 2, "mbar" or "inHg" will begin to flash.
6. PRESS the [+] button to toggle between "mbar" and "inHg".
7. At the unit of measure desired, PRESS the [Select] button to move to the next unit. Located at the top right
in Field 1 (just above the bubble), °C or °F will begin to flash.
8. PRESS the [+] button to toggle between °C and °F.
Imperial Unit of Measure
ft
ft/min
°F
inHg
10