Stack Dryer Sloped Front (Pr Model); Microprocessor; Stack Dryer-Mn Models; Front Panel - Maytag MDE/MDG21PDA Service Manual

Disassembly Procedures
!
5. Tip the top of the front panel forward and slightly
lift the Front Panel at the same time. Then
remove the wires from the door switch.
Tip
Forward
& Lift up
Slightly
6. With the wiring removed from the door switch,
continue to tilt the front panel forward while
lifting the panel to clear the two lower mounting
brackets.
©2004 Maytag Appliances Company
WARNING
Remove
Screws
16022904 Rev. 0
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
STACK DRYER SLOPED FRONT (PR
MODEL)
Note: The following is exclusive to the PR Model -
sloped Front Dryer.

Microprocessor

1. Disconnect power supply to unit.
Note: Display is larger on "PR" model dryers.
2. Remove four security screws securing facia.
3. Remove three screws securing the microprocessor to
the Control Console.
4. Remove Control Panel.
5. Disconnect wiring connections.
6. Remove Microprocessor Board and bracket.

STACK DRYER-MN Models

Note: The following section is exclusive to the MN
stack dryers.

Front Panel

1. Disconnect power supply to unit.
2. Remove two front screws.
3. Swing panel out and away from dryer.
53