Gsm; Gsm Mode; Setting The Gsm Feature - Hanna Instruments PCA 311 Instruction Manual

GSM

GSM MODE

Alarm SMS which contains the Error, Alarm and Warning messages
Info SMS
Warning SMS which contains information about the SIM card credit.

SETTING THE GSM FEATURE

Note:
5 8
If the "Type" is set to GSM, the analyzer will work with HI 504900
GSM module. This connection enables the analyzer to send
SMSs to one (or two) cellular phone(s) and through this
feature the device can be monitored. Moreover if an error
occurs on the PCA 3x1, a SMS is sent to the cellular phone(s)
signaling immediately the user about the problem.
When the SMS feature is active, three type of SMS messages
are sent to the selected cellular phone(s).
that are active on the analyzer, separated by ';'. The events
that generate the alarm SMS are user selectable from
"General Menu" - "SMS Settings".
which contains the Bromine, pH, ORP and Temperature
readings. Analyzer's error status and settings are also included
as selected by the user from "General Menu" - "SMS Settings".
The settings related to GSM are grouped in "General Menu"
- "Serial & GSM Comm.".
To use the SMS feature, a SIM card able to make voice calls
must be used.
It is necessary to enter
the PIN code of the
SIM card inserted in
the GSM module. To
do this, set the
"General Menu" -
"Serial & GSM
Comm" - "PIN No.".
The PIN number is not
visible after editing for
protection reasons.
The field will always
show 0000.
Type :STANDARD
Baud Rate:9600
Address: 01
Send SMS :Inactive
PIN No. :0000
Phone 1 :Inactive
No1:---------------
Phone 2 :Inactive
No2:---------------
Charge Inf:Inactive
Exp.Date:2010/01/01
Remaining:0000
RepeatNo:2
Delay :05
Remote :Active
min