Advertisement
Quick Links
SRX I
NSTALLED
SRX Corvette C-6 Installation Tips
We recommend bench assembling the entire system if you are a first time installer.
We also recommend reading the installation manual. Power can be applied and all
programming options selected on the bench or in the vehicle.
Power and Ground:
R
& L
ADAR
ASER
D
S
EFENSE
YSTEM by
The fuse box is
located in the
passenger's foot well
against the firewall.
ESCORT
Advertisement
Related Manuals for Escort SRX Corvette C-6
Summary of Contents for Escort SRX Corvette C-6
- Page 1 ASER EFENSE YSTEM by SRX Corvette C-6 Installation Tips We recommend bench assembling the entire system if you are a first time installer. We also recommend reading the installation manual. Power can be applied and all programming options selected on the bench or in the vehicle.
- Page 2 Locate a switched fuse and tap into the hot leg. Ground for power can also be found on the Bose amplifier case. Pull the carpet back to expose the fuse box. The interface (Letter Code F on the Installation Manual) will fit in the cavity under the Bose unit.
- Page 3 The Remote Mute Button (Code letter H on the installation manual) should be located within easy reach of the driver. NOTE: This button has three functions – please consult the owner’s manual for explanation. The Bi-Colored Concealed LED Display (optional HV model) can be mounted in the “crease”...
- Page 4 Front Laser Shifters: The Front Laser Shifters (Code letter B on the installation manual) can be mounted different ways. They can be mounted inside the grill area as on the Yellow Z06 with the supplied mount brackets and 3M Scotch VHB double sided tape (follow surface preparation and temperature instructions for the...
- Page 5 This is much easier when taping the wires individually to the 1/8 inch metal rod and pushing through. Once all wires are on the other side of the firewall you will need to cut the wires to length and put new phone jack connectors on. (Suggested replacement plugs and the cut / crimper part numbers and suppliers are noted on the...
- Page 6 Interface: Ensure all jacks are plugged into the interface. Use cable ties on the mute switch and amplified speaker jacks. Place wiring into the cavity and cover everything back up. Once the unit is tested put all body and interior components back in place.
- Page 7 Important tips for cutting modular cables and crimping modular jacks Step 2: Place cable in strip part of crimp tool and rotate Step 1: Cut modular cable in crimp tool as shown. wire in a circular direction to remove outside jacket. Be sure not to knick the insulation on the separate strand of wire.