Advertisement
Important tips for cutting modular cables and crimping modular jacks
Step 1: Cut modular cable in crimp tool as shown.
Crimping Too: Mouser Part Number 382-2094C
Mouser Electronics, Inc. Phone 800.346.6873
1000 North Main St.
Mansfield, TX 76063
Step 3A: Color sequence of wires placed in modular plug for
front shifters, rear shifters, and display module.
Modular Connector Digi-Key PN A9091-ND 4 Pos / 4 Cont
Digi-Key Corporation
701 Brooks Ave South
Thief River Falls, MN 56701
Step 3B: Color sequence of wires
placed in modular plug for Radar
receiver.
Step 3C: Color sequence of wires
placed in modular plug for Concealed
display.
Step 4: Place modular plug with cable
into location as shown. Squeeze
handles together until they stop.
www.mouser.com
Phone 800.344.4539
www.digikey.com
Step 2: Place cable in strip part of crimp tool and rotate
wire in a circular direction to remove outside jacket. Be sure
not to knick the insulation on the separate strand of wire.
Yellow
Red
Green
Blue
White
Orange
Blue
No wire
Yellow
Red
No wire
Blue
Advertisement
