2.19 Setting the Pressure Foot
42
4
1
2
3
Caution Risk of Injury!
Before adjusting turn the main switch off.
Replacing the sole on the sewing foot
Order no.
–
Press spring 4 down.
–
Pull the foot off to the side.
–
Push on another foot until the spring 4 catches.
Adjusting the sewing foot
IMPORTANT
Adjustments must always be carried out with the PTFE foot in place.
This ensures that the settings for the steel foot will also be correct.
With the feed dog at top dead centre (position B) the PTFE foot 2 must
be in flush contact with the feed dog.
–
Stop machine in position B.
–
Undo screw 3.
–
Align PTFE foot 2.
–
Tighten screw 3.
When the screw 3 is tightened, the plate 1 must be pressed down
(see arrow) so that the stop makes contact with the base plate.
PTFE foot 0196 104008
steel foot
0196 104010