Thread Take-Up Disk - Duerkopp Adler 550-12-23 Service Instructions Manual

2.17 Thread Take-up Disk

36
1
The thread take-up disk should, with the machine arrested in slot B
(upper dead center), lie 4 mm above the support plate 1.
Caution Risk of Injury!
Before adjusting turn the machine off.
–
Loosen the screws on the thread take-up disk.
–
Arrest the machine in position B.
–
Turn the thread take-up disk appropriately. With the gauge 7 set
the correct dimension.
–
Set the disk close and tighten the screws.
Gauge 7