FX-980
1.4.2 Printable Area
Printable area for the FX-980 is the same as for the FX-2170 exept for
the point below:
Cut Sheet:
<FX-980>
Left Margine
3 mm or more (Paper width is 216 mm)
(Single/Multipart)
27 mm or more (Paper width is 257 mm)
<FX-980>
Right Margine
3 mm or more (Paper width is 216 mm)
(Single/Multipart)
27 mm or more (Paper width is 257 mm)
Product Description
1.4.3 Interface Specifications
This printer provides bi-directional 8-bit parallel interface, serial
interface, and Type-B interface ooptional interface card slot as
standard.
For information that is not covered in this section, refer to the FX-2170
Service Manual.
1.4.3.1 Parallel Interface (Forward Channel)
Transmission mode:
Signal level:
Pin assignment:
Pin No.
Function
18
<FX-980> This line is pulled up to +5 V through 3.9 k
35
<FX-980> This line is pulled up to +5 V through 1.0 k
BUSY signal is active (HIGH level) under the conditions below:
In addition to the conditions given in the FX-2170 Service Manual,
If -ERROR or PE signal is active (low level, high level,
respectively).
-ERROR signal is active (low level) under the conditions below:
If there is a paper-out error.
If there is a release lever error.
If there is a cover open error.
PE signal is active (high level) under the condition below:
If therer is a paper-out error.
Firmware Specifications
Revision A
IEEE-1284 compatibility mode
TTL compatible
IEEE-1284 level 1 device)
The pin assignment (forward channel) is
the same as for the FX-2170 except for
the function of the pins below:
resistor.
resistor.
20