Table of Contents
Advertisement
Button [1]
[FM AM] button
Button [3]
Changing the reception sensitivity for automatic scanning
The deck lets you select the reception sensitivity to be used for
automatic scanning of stations. The two sensitivity modes available
for this deck are AUTO mode and DX mode.
AUTO Mode
DX Mode
1
Check that the deck is in standby mode.
Press and hold the button [1], then [FM AM] button, and
2
hold both for more than three seconds.
The mode switches between AUTO mode and DX mode each
time the buttons are pressed.
Changing the radio band location
You can switch the location for the radio bands used between the
North American region and the Asia/Australia region. The default
setting is USA (North America).
1
Check that the deck is in standby mode.
Press and hold the button [3], then [FM AM] button, and
2
hold both for more than three seconds.
The radio band switches between USA and OTHERS each time
the buttons are pressed.
After changing the location, the power will turn on in FM1
mode. After this, the broadcast stations will be searched for
automatically and stored in buttons [1] to [6].
During automatic scanning, the reception sensitivity
switches automatically to one of two levels. Initially the
reception sensitivity is set to the low level so that only
stations with strong signals are received. If no stations
could be received, the reception sensitivity is increased
so that stations with weaker signals can also be
received.
Because the reception sensitivity for automatic scanning
is set to the high level from the start, even stations with
weaker signals can be received. (Signal crossover may
result in some stations being hard to hear.)
45
How to operate the tuner
Advertisement
Table of Contents
