Setting The Hook Feet Of Button Clamp - Duerkopp Adler 530 Operating Instructions Manual

7.10 Setting the hook feet of button clamp

2 1
Caution: Danger of injury !
Set the button clamp while the button sewing automat is switched
on with utmost caution only.
The button should be easily pushed and aligned between the hook feet
of the button clamp.
It is also important that the button is properly jammed, so that it cannot
contort when the material is inserted.
The stop 3 regulates the opening width of the hook feet.
–
Switch on the button sewing automat.
The clamp button rises.
–
Put the button that is to be attached between the hook feet 1 and 2.
–
Loosen the knurled nut 5.
–
Set the stop 3 so that it approaches the screw 4.
–
Fasten the knurled nut 5 again.
–
Check whether the button can easily be inserted and aligned.
5 4 3
1
17