PCI Card Support
For added protection, some cards have PCI holders installed to prevent movement during shipping.
REMOVING CARD SUPPORT
1
Disconnect power from the system
workstation on its side with the system board facing up.
2
For short or tall PCI cards, press down on the holder arm
arm 2.
1
INSTALLING CARD SUPPORT
1
Disconnect power from the system
workstation on its side with the system board facing up.
2
Attach the card support arm on different sides of the chassis slots depending on if supporting a short
or tall card. Use the following images as a guide and also the imprint on the card support arm.
For short cards, attach the lip of the support arm over the chassis slot
the arm over the PCI retainer 2.
For tall cards, attach the lip of the support arm under the chassis slot
the arm over the PCI retainer 2.
(page
68), remove the access panel
2
(page
68), remove the access panel
1
2
REMOVAL AND REPLACEMENT OF COMPONENTS 87
(page
74), and lay the
1
while lifting up on the other side of the
1
2
(page
74), and lay the
1
and pull the lower part of
1
and pull the lower part of
1
2