Zanussi ZDI11002 User Manual page 18

German
degrees
(°dH)
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
Manual adjustment
1
Electronic adjustment
1. Make sure that the programme marker on the pro-
gramme knob is aligned with the on/off indicator.
2. Press and hold the start button. At the same time turn
the programme knob clockwise until the programme
marker is aligned with the first programme on the
control panel.
3. Release the start button when the start indicator and
the on/off indicator start to flash.
• The end indicator flashes intermittently. The num-
ber of flashes shows the level of the water softener.
Example: 5 flashes + pause + 5 flashes = level 5.
4. To adjust the level of the water softener, press the
start button. Each time you press the start button you
go to the next level.
5. To confirm the setting, turn the programme knob until
the programme marker is aligned with the on/off indi-
cator.
18
Water hardness
French
degrees
(°fH)
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7
2
Turn the water hardness
dial to the position 1 or 2.
mmol/l Clarke
degrees
18 - 22
13 - 17
5 - 12
< 0.7 < 5
Filling the salt container
Caution! Only use dishwasher salt. Other products
can cause damage to the appliance.
Water and salt can come out from the salt container when
you fill it. Risk of corrosion. To prevent it, after you fill the
salt container, start a programme.
1
3
Put 1 litre of water in the
salt container (only for the
first time).
Water softener
adjustment
Manual Electronic
1 4
1 3
1 2
2) 2)
1 1
2
4