Advertisement
Introduction
The Dymo LabelPoint 200 enables you to create a wide
variety of high quality self-adhesive labels of up to 90
characters.
The LabelPoint uses 6mm (
(
1
/
") wide tape cassettes in a number of label colours.
2
Labels are back slit for easy removal from the backing
tape. Text can be printed horizontally or vertically in a
variety of sizes and styles and can be left-justified, right-
justified or centred on the label.
Visit www.dymo.com for information on obtaining tapes
and accessories for your LP200.
Warranty Registration
Please complete the warranty registration card and return
it to the relevant address, within seven days– see the
warranty booklet for details.
Power Supply
BATTERIES
• Apply pressure to thumb catch then open and lift away
battery compartment cover – see fig
• Insert six size AA alkaline or re-chargeable Nickel-
cadmium batteries, observing the polarity markings
A—
, and close the cover.
• Remove batteries if the LabelPoint is to be unused for
some time.
AC ADAPTOR (optional)
• Connect the AC adaptor to socket
adaptor plug disconnects the supply from the batteries.
• Unplug the AC adaptor from the LabelPoint before
disconnecting the mains power to the adaptor,
otherwise last label memory settings may be lost (see
also ON/OFF).
Changing the cassette
• Press catch in and open hinged access door
• Hold as shown, then lift cassette
out.
• Ensure tape and ribbon
cassette and tape passes between guideposts before
installing as shown. If necessary, turn spool
clockwise to tighten ribbon.
• Check that cassette switch
– see page 2. A notch in the cassette will fit over the
switch when it is set correctly.
• Insert cassette with tape and ribbon positioned as
shown between print head
C˜
• Push firmly
until cassette clicks into place. Ensure
tape and ribbon are positioned correctly.
B–
• Close door
until it clicks shut.
1
3
/
"), 9mm (
/
") or 12mm
4
8
A–
, page 2.
A˜
. Inserting the
B–
.
B—
straight up and
B˜
are taut across mouth of
B❹
B❺
is set for the cassette type
C–
C—
and pinch roller
Creating your first label
You will no doubt be anxious to see what your
new LabelPoint 200 can do. Before we go on to explore
the many advanced features of the LP200, follow these
simple steps to create your first label:
1. Fit the batteries, or connect the AC adaptor, plug in and
switch on at the wall socket - see 'Power Supply'.
2. Open the cassette compartment lid and check that the
tape cassette is fitted correctly – see page 2 and
'Changing the Casette'.
3. Close the lid, then press
The display should look like this:
4. Use the keyboard to type in your full name.
Each character you enter will appear on the display, for
example:
• For an UPPER CASE character, press and hold down
followed by the character required.
• Press
CAPS
CASE.
• Press the space bar once for the space between each
name.
If you make a mistake, press
then type in the correction.
5. When you have finished, press
printed and will emerge from the slot in the top right
hand side of the machine. Wait until the mechanism
has stopped, then press the cutter lever E to cut off the
label and remove it from the machine.
You should now have a high quality printed name label —
don't waste it! If this is your personal machine, why not
fix the label to the underside to identify its owner? You
have just found the first of many uses for your DYMO
labels.
.
3
to switch the power on.
Cursor flashing
DYMO
for all subsequent characters in UPPER
DEL
. A label will be
PRINT
DYMO
GB
1
1
to delete the error,
Hide quick links:
Advertisement
