Connecting A Pc; Adjusting The Pc Image Automatically; Adjusting The Pc Image Manually - Sharp Aquos LC-32LE600E Operation Manual

Connecting a PC

Connecting a PC
HDMI Connection
PC

HDMI-certified cable
PC

DVI/HDMI cable
* When using the HDMI 2 terminal, you must select the proper
item in the "PC Audio Select" menu depending on the type of
HDMI cable connected (Refer to page 19 for details).
Analogue Connection
PC

RGB cable
PC

DVI/RGB conversion
cable
* When using the EXT 4 terminal, you must select "EXT 4 (RGB)"
in the "PC Audio Select" menu (Refer to page 19 for details).
NOTE
• The PC input terminals are DDC1/2B-compatible.
• Refer to page 27 for a list of PC signals compatible with the TV.
• When connecting to a PC, the input signal type is automatically
detected.
HDMI 1, 2 or 3
HDMI 2*

ø 3.5 mm stereo
minijack cable
EXT 4*

ø 3.5 mm stereo
minijack cable
EXT 4*

ø 3.5 mm stereo
minijack cable
Adjusting the PC image
automatically
This function enables the screen to be automatically
adjusted to its best possible condition when the analogue
terminals of the TV and PC are connected with a
commercially available DVI/RGB conversion cable, etc.
Setup
Auto Sync.
NOTE
• "Auto Sync." may fail if the PC image has low resolution, has
unclear (black) edges, or is moved while executing "Auto
Sync.".
• Be sure to connect the PC to the TV and switch it on before
starting "Auto Sync.".
• "Auto Sync." can be executed only when inputting analogue
signals through the EXT 4 terminal.

Adjusting the PC image manually

Ordinarily you can easily adjust the picture as necessary
to change image position using "Auto Sync.". In some
cases, however, manual adjustment is needed to
optimise the image.
Setup
Fine Sync.
Press a/b to select the specific adjustment
1
item.
Press c/d to adjust the item to the desired
2
position.
H-Pos.
V-Pos.
Clock
Phase
Centres the image by moving it to the
H-Pos.
left or right.
Centres the image by moving it up or
V-Pos.
down.
Adjusts when the image flickers with
Clock
vertical stripes.
Adjusts when characters have low
Phase
contrast or when the image flickers.
NOTE
• For resetting all adjustment items to the factory preset values,
press a/b to select "Reset", and then press ;.
• "Clock" and "Phase" in the "Fine Sync." menu can be adjusted
only when inputting analogue signals through the EXT 4
terminal.
Item
25