REFRIGERATORS WITH BOTTOM MOUNT CONTROLS
Refrigerators with Piezo lgnitors
(RM2310 & RM2410)
A -
ON/OFF Switch
B - Thermostat Gas/Electric
c
Safety Push-button
-
D - Piezo lgnitor
E -
Flame View Port
GAS OPERATION
Piezo lgnitor (RM2310 & RM2410)
Refrigerators with
To start the
refrigerator, turn knob
Turn the thermostat knob "B" one-quarter (l/4) of a turn from the "OFF" position.
in until it bottoms out-and hold. While holding button "C", push button "D" for the
Push button "C"
piezo ignitor several times to light the burner. This can be observed through the flame view port, "E",
on the refrigerator.
After the flame lights, continue to hold button "C" for an additional fifteen (15) seconds. Release the
button "C" and check the flame view port "E" to make sure the burner does not go out. If the burner
goes out, repeat the lighting procedure.
To shut off the refrigerator, turn Knob "A" to the "OFF" position.
Refrigerators with Automatic Reigniters (RM2510/RM2610 /RM2810)
To start the refrigerator, turn knob "A" to the "GAS" position.
Turn the thermostat knob "6" one-quarter (l/4) of a turn from the "OFF" position.
Push button "C" in until it bottoms out-and hold. When lamp
an additional 15 seconds. Release button "C". If the lamp
procedure. If flame blows out, the reigniter will automatically relight the flame.
Refrigerators with Automatic Reigniters
(RM251 O/RM261 O/RM2610)
A
B - Thermostat, Gas/Electric
c
E -
"A"
to the "GAS"
position.
4
ON/OFF Switch
-
Safety Push-button
-
Light
"E"
stops flashing, hold push-button "C"
"E"
starts to flash again, repeat lighting