Denon CEOL Piccolo DRA-N5 Owner's Manual page 15

Speaker Optimization
An optimizing filter suited for the properties of the speakers (SC-N5)
can be used.
1
Press SETUP .
Turns on the Menu settings mode
and the Menu appears on the display
(vpage 9 "Menu map").
2
Use ui and ENTER to
select "General" – "Speaker
Optimization", then press
ENTER p
or .
"Speaker Optimization" menu appears.
3
Use ui to select "On", then
ENTER p
press or .
The response is optimized for the speakers (SC-N5, sold
On
separately).
Off
The response is flat.
Language
Sets the language for display the menu.
• The factory language setting is "English".
1
Press SETUP .
Turns on the Menu settings mode
and the Menu appears on the display
(vpage 9 "Menu map").
2
Use ui and ENTER to select
"General" – "Language", then
press ENTER or p .
/ Français / Español
English
Auto-Standby
When this unit is in the stop state and there is no input signal and
operation for 30 minutes, it automatically enters the standby mode.
For the input source "AUX:Analog In" only, when no operation is
performed for eight hours, this unit automatically enters the standby
mode.
• The default setting is "Off".
1
SETUP
Press .
Turns on the Menu settings mode
and the Menu appears on the display
(vpage 9 "Menu map").
2
ui ENTER
Use and to select
"General" – "Auto-Standby",
ENTER p
then press or .
"Select Auto-Standby" menu appears.
3
Use ui to select "On", then
ENTER p
press or .
The setting is entered.
NOTE
In the following situations, the Auto-standby function does not operate.
• When the source is "iPod" (Remote mode) or "AirPlay".
12
Setting the general [General]
Firmware
n Update
• In order to update the firmware, the environment and settings
required for connecting to broadband internet are needed
(vpage 7).
• Perform the firmware update operation after at least 2 minutes has
elapsed since turning this unit's power ON.
1
Press SETUP .
Turns on the Menu settings mode
and the Menu appears on the display
(vpage 9 "Menu map").
2
Use ui and ENTER to select
"General" – "Firmware" –
"Update", then press ENTER or
p
.
Check For Update Check for firmware updates. You can also check
approximately how long it will take to complete
an update.
Update Start
Execute the update process.
• If updating fails, the set automatically retries, but if updating is still
not possible, one of the messages shown below is displayed. If
the display reads as shown below, check the settings and network
environment, then update again.
Display Description
Updating fail Updating failed.
Login failed Failure to login to server.
Server is busy Server is busy. Wait a while then try again.
Connection fail Failure in connecting to server.
Download fail Downloading of the firmware has failed.