Samson MDR1064 Owner's Manual page 9

(MONO/STEREO INPUT CHANNEL CONTINUED)
NOTE: The channel's AUX 2 signal is sent to the AUX 2 bus from a location in the signal path after the
channel's LEVEL control. This is commonly referred to as a POST FADER send. This means that the
amount of signal that is sent to the AUX 2 bus will be affected not only by the setting of the AUX 2 knob
control, but it will also be affected by the setting of the LEVEL control.
6
BALANCE (Stereo Inputs Only)
The MDR1064's BALANCE control is used to place or position the
stereo signal into the main Left and Right MIX bus. You can move a
stereo signal's image to the left or right by setting the BALANCE
control to the left or to the right.
7
PAN (Mono Inputs Only)
The MDR1064's PAN control is used to place or position the mono
signal into the stereo main Left and Right MIX bus. You can create a
stereo image by panning some input signals to the left and others to
the right. The MDR1064's PAN control is a Power-Pan circuit, which
includes a 3dB dip in the center position. This is desirable since
there's a 3dB increase in gain when the mono input signal is heard
in both the Left and Right MIX bus.
8
PEAK LED
The MDR1064's MIC/LINE pre-amp also includes a PEAK LED
which, when illuminated, indicates that the signal is peaking or over-
loading. To reduce distortion, lower the GAIN control to keep this
LED from staying on.
9
CHANNEL LEVEL
The MDR1064's LEVEL control knobs are used to adjust the overall
channel volume.
Controls and Functions
7
6
7
8
9