Master Section; Controls And Functions - Samson MDR1064 Owner's Manual

Controls and Functions

MASTER SECTION

MAIN LEVEL
10
The master MAIN control is the overall volume control for the left and right mix bus. These line level signals
are output from the MAIN MIX jacks.
11
PHONES / CR
The PHONES / CR control is used to set the level sent to the
control room outputs, and also to the headphone jack.
2 TRACK INPUT AND OUTPUT
The MDR1064's 2 Track section provides the connections for play-
back and recording for an external device such as a DAT, cassette
recorder, CD or Mini Disk.
12
2TK TO CR
The 2TR TO CR switch is used to assign the 2TR input to the
Control Room output. If you push down the 2TK TO CR button,
signal will be routed into the left and right Control Room output
and will be adjusted by the CR / PHONES control knob.
13
2TK TO MIX
The 2TR TO MIX switch is used to assign the 2TR input to the
MAIN mix bus. If you push the 2TR TO MIX button, the signal
present at the 2 TRACK IN will be routed to the left and right
MAIN output and the level will be controlled by the MAIN
LEVEL knob.
Auxiliary Returns
The MDR1064 has two stereo auxiliary returns, which can be
accessed via the two pairs of 1/4-inch phone jacks located on the
master section jack field. The auxiliary returns can be used to con-
nect any stereo line level signal, but they are primarily used to con-
nect the output of external effects processors.
14
AUX RET 1
This adjusts the amount of signal that is sent from the AUX 1
RET jacks to the MAIN bus.
13
12
8
14
11 10