Using Scsi Select - HP Kayak XU 03xx Manual

NOTE
ATTENTION
HP Kayak XU 03xx PC Workstation Configuring a SCSI Accessory
There are two ways to configure a SCSI accessory:
SCSISelect — for use with Internal Wide 16-bit SCSI devices
•
& HP FastRAID (Adaptec).
SCSI Configuration Utility — for use with External and Internal
•
16/8-bit SCSI devices (Symbios).
You cannot boot from a device connected to the Symbios controller
when HP FastRAID is installed.
To disable a boot device:
1 Go to the
Advanced
2 Select the SCSI channel you wish to set.
3 Enable or disable the

Using SCSI Select

™
The SCSISelect utility is intended for advanced users only.
Note that the SCSISelect options displayed on your screen may
be different from those described here. Some options are not
displayed if the HP FastRAID option is installed.
The SCSISelect utility is accessed by pressing
computer's start-up process when the message
SCSISelect(TM) Utility!
2 English
menu in the Setup program.
Option ROM Scan
is displayed.
as required.
during the
Press for