When an IDE CD-ROM
Drive Is Installed
HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Desktop PC Workstation
Installing Mass Storage Devices
8 Connect the data and power cables to the rear of the device. (The
connectors are shaped to go in one way only.)
9 Replace the HP UltraFlow airflow guide.
10 Remove the plastic panel from the cover by pulling the panel from
the left and unhinging its right-hand side. Store the panel in a safe
place.
11 Install any other accessories before replacing the cover and
completing the installation.
Completing the Installation of a Drive
1 Switch on the computer and press
2 In the Setup program, select the Advanced menu, the IDE Devices
submenu. Check that the CD-ROM drive has been detected on the
IDE channel.
3 Press
to save and exit the program.
20
English
Power Cable
Data Cable
Unclip and lift out the
plastic panel.
when
appears.
Setup