HP Kayak XA-s 02xx Manual page 11

Which Data
Connectors to Use
Which Power
Connectors to Use
HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Desktop PC Workstation
Your PC Workstation has the following cables and connectors which can
be used for mass storage devices:
A floppy disk drive cable with a single connector (connected to the
•
floppy disk drive supplied).
Two Ultra ATA/33 IDE drive cables that support up to four fast IDE
•
devices. If you install a CD-ROM drive, CD-RW drive, a Zip drive, or
a third hard disk drive, connect it to the second IDE cable.
On selected models, the Ultra SCSI 16-bit interface board, installed
•
in a PCI slot, supports up to 13 external SCSI devices and
automatically switches to non-Ultra or standard mode.
There are two different types of power connectors—these are shown
below.
Some of the power connectors will already be connected to devices. If
you install a device that requires a different connector, the connector
converter should be supplied with the device.
Installing Mass Storage Devices
Power Cables for Hard Disk
Drives, Zip Drives, Tape Drives,
CD-RW, and CD-ROM Drives
Power Cable for 3.5-inch
Floppy Disk Drive
English 11